...
More information on the IP Address and Ranges can be found here
UAS IP
...
Ranges
...
Accessing the Network
Configure ground station computer(s) to use DHCP
Connect ground station computer or network
If using an original BFD GCS with two ethernet ports
Connect the battery and depress the power button
Connect a network cable to either port of the ground radio unit
If using a Doodle Labs Wearable Radio
Attach a power supply (battery or USB-C)
Power on the
radio by holding the power button for 4 seconds
Connect to a PC using one or more of the following
USB-D port (if using USB directly)
USB-H port (if using the Ethernet adapter)
WiFi Hotspot (if using a short range wireless connection)
WiFi Default Password: 1BigDroneRadio
See the following links for more information on connecting to the wearable unit
Power on the aircraft (if connecting to aircraft systems)
...
Follow the instructions above to connect the computer to the network
Open a Mavlink compatible Ground Control Station software
Using Mission Planner
In the top right corner select the drop down menu and select UDPCI
Enter the IP address of the aircraft serial adapter (10.x.y.2)
Click Ok
Enter 14550 14500 for the local port
Use port 14550 for earlier aircraft
Check sticker on ground radio or aircraft network print out if unsure
Click ok
Using QGroundControl
Select the Purple icon in the top left of the screen to go to settings
Select Comm Links in the sidebar
Click Add at the bottom of the screen
Enter a name for the Vehicle
Choose type UDP
Enter 14550 14500 for the listening port
Under target host click add
Enter the flight controller IP address
Listed in the UAS Radio and Network Sheet included with the aircraft
It may also be listed on a stick on the ground radio unit
Click Ok
Select the new link in the menu
Click connect
...
For information on accessing the stream from a video encoder please see the page linked below.