Skip to end of metadata
Go to start of metadata
CAN | Pin 1: 5V Pin 2: CAN_H Pin 3: CAN_L Pin 4: GND
|
Serial A | Pin 1: 5V Pin 2: Serial 2 RX Pin 3: Serial 2 TX Pin 4: Serial 2 CTS Pin 5: Serial 2 RTS Pin 6: Ground
|
Serial B | Pin 1: 5V Pin 2: Serial 4 RX Pin 3: Serial 4 TX Pin 4: Not Connected Pin 5: Not Connected Pin 6: GroundÂ
|
PWM | Pin 1: 5V Pin 2: Servo 11 (Aux 3) Pin 3: Servo 12 (Aux 4) Pin 4: Servo 13 (Aux 5) Pin 5: Servo 14 (Aux 6) Pin 6: Not Connected Pin 7: GND
|
SBus | Pin 1: S.Bus Signal Pin 2: 5V Pin 3: GND
|
Ethernet A & B | Not Used on SE-8 Model A Aircraft |
Each connector is equipped with a switch to enable to disable the 5V output on that connector. An LED will indicate if the port is providing 5V power. All data pins are connected regardless of switch position.