Alta X Cargo Landing Gear Assembly

This page will show you how to assemble the Cargo Landing Gear for the Alta X. All you will need is a 2mm hex driver for this.

In the box:

1x Landing gear ridged top

2x Landing gear strut

4x Landing gear leg

Step 1: Loosen the 4 thumb screws on the ridged top.

Step 2: Insert the legs then tighten the thumb screws.

Step 3: Add strut to landing gear legs. Insert legs into the clamps and adjust to required height. Use the 2mm hex driver and 242 loctite on the M2.5x6 socket head screws. It’s recommended to torque the screws to 0.4 Newton meters (3.59in lbs.)

If you tighten these screws too much the carbon could be crushed.

The cargo landing gear is now assembled. ENJOY!